Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Comsol and Matlab - avoid unnecessary recalculations
Posted 19 avr. 2011, 09:04 UTC−4 Interfacing, LiveLink for MATLAB Version 4.1 0 Replies
Please login with a confirmed email address before reporting spam
I am working about a flexible model using Comsol 4.1 and Matlab.
Meanwhile the model is quite big and takes already some Minutes of calculation with a very rough mesh and only few couplings.
The problem is, that for obtaining solutions, I have to type mpheval... and for displaying the mesh, for instance, I need to run mphmesh..... . For that, two calculations are done, which is unnecessary.
Is there a possibility, like in Comsol 3.5 with MATLAB, to store the whole solution of a model in a variable, which the commands (mph...) can be run on, without recalculating for every step?
Hello Philipp Fischer
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.