Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

getting a curve in draw mode from a plot in post processing mode

Posted 9 juil. 2009, 05:00 UTC−4 0 Replies

nitin jaiswal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hello everybody,

I am solving a two phase flow problem and i have solved for the interface between the fluids. But i am stuck with drawing that interface in solving a problem in next step. Is there an easier way of getting a curve in DRAW MODE from the coordinates from post processing plot. One way can be plotting manually all the points and join them through points but its too cumbersome and tedious.

Could nybody plz help me out with this?

Nitin.
0 Replies Last Post 9 juil. 2009, 05:00 UTC−4
COMSOL Moderator

Hello nitin jaiswal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content