Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

creating multiple cut planes

Posted 18 mars 2011, 14:45 UTC−4 Version 4.1 3 Replies

Jordan Blimbaum
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to integrate over an xy cut plane, for multiple xy planes spaced equally along the z axis. (then i am going to plot the integral solution vs z). currently i am doing this by creating a separate cut plane for each integration. but i have many cut planes and it is becoming very tedious! is there a way to create some kind of a batch cycle to create multiple cut planes at once? thanks!
3 Replies Last Post 4 déc. 2015, 09:29 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19 mars 2011, 04:57 UTC−4
Hi

in 2D you can add additional parallle lines for a Line cut. Just notice that the range you define is positive in the up normal direction of the edge/line, and that is in the counter-clock wise direction. In other words the range you enter should be negative for default 0,0 to 0,1 direction lines

This has NOT (yet ?) been implemented into 3D cut planes I see
(why not send a mai to support as a suggestion ;)

--
Good luck
Ivar
Hi in 2D you can add additional parallle lines for a Line cut. Just notice that the range you define is positive in the up normal direction of the edge/line, and that is in the counter-clock wise direction. In other words the range you enter should be negative for default 0,0 to 0,1 direction lines This has NOT (yet ?) been implemented into 3D cut planes I see (why not send a mai to support as a suggestion ;) -- Good luck Ivar
Jordan Blimbaum
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21 mars 2011, 13:02 UTC−4
Thanks Ivar, I will make this suggestion
Thanks Ivar, I will make this suggestion
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 4 déc. 2015, 09:29 UTC−5
Not sure about back at version 4.1, but there are currently (i.e.at version 5.2) at least two easy ways to do this: see www.comsol.com/community/forums/general/thread/94851/
Best,
Jeff
Not sure about back at version 4.1, but there are currently (i.e.at version 5.2) at least two easy ways to do this: see http://www.comsol.com/community/forums/general/thread/94851/ Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content