Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comsol 5.2a fluid flow model -3-D

Posted 17 sept. 2017, 15:41 UTC−4 0 Replies

Jesudoss
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, Formy 3-D model analysis I am tring to use the cluster facility and I am getting a warning as below: ------It appears that your cpomsol job is typing to make use of 96 threads, but you are only requesting 8 cores for your job.Please adjust the number of threads and resubmit teh job"

Can anyone give advice?

0 Replies Last Post 17 sept. 2017, 15:41 UTC−4
COMSOL Moderator

Hello Jesudoss

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content