Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to use Matlab commands to simulate in COMSOL

Posted 9 mars 2011, 18:28 UTC−5 Version 4.1 1 Reply

Ying Peng
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Can I just write commands in matlab and run it in COMSOL?

Like Ansys, I could write command flow and click run to get the results I want.

Thanks.

1 Reply Last Post 10 mars 2011, 00:58 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 mars 2011, 00:58 UTC−5
Hi

yes and no ;)
read the doc, you can set up your model, or load it in and control the solving from matlab, but its not "just one command"

--
Good luck
Ivar
Hi yes and no ;) read the doc, you can set up your model, or load it in and control the solving from matlab, but its not "just one command" -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content