Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to set Boundary Condition as PDE in COMSOL

Posted 30 juil. 2017, 11:07 UTC−4 Low-Frequency Electromagnetics Version 4.3b 0 Replies

NDN UNIST/Mechanical Engineering
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all
I am modeling my project, and I need to set my boundary condition as PDE, i.e d(U,x)=0 in Electrostatic physic, but actually, I didn't find any way to do this.
Does anyone know how to do this?
Best regards
0 Replies Last Post 30 juil. 2017, 11:07 UTC−4
COMSOL Moderator

Hello NDN

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content