Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Contact problem in 2D modeling

Posted 9 mars 2011, 05:16 UTC−5 0 Replies

Ali
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,
I have problem with contact in 2D, I modeled a long beam with small cross section area. and I have a block below it (the gap between beam and block is so small). I want to define contact between block and beam but it goes inside the block.
please help me?

file is attached

Attachments:

0 Replies Last Post 9 mars 2011, 05:16 UTC−5
COMSOL Moderator

Hello Ali

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content