Discussion Forum

Forum Home

New Discussion

Note: This discussion is about an older version of the COMSOL Multiphysics^® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

A question on the contact problem

Posted 4 mars 2011, 18:28 UTC−5 Structural Mechanics Version 4.1 1 Reply

Jifeng Hu

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi folks,

When I read the contact problem on the comsol manuals, I had this understanding: only the destination domain receives the contact pressure and friction, but not for the source domain. Is that correct? If it is right, then it means that the source domain is not subject to the contact forces. This is against the Newton's third law of motion.

I appreciate any help from you.

Thanks,
Jifeng

1 Reply Last Post 5 mars 2011, 03:46 UTC−5

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Hi

I do not believe so.

The contact force goes, for me, between the two parts in equal but opposite directions.
Otherwise you will not have the coservation of forces.

But its true that you have a variable that allows you to add some "initial" contact pressure, defined on one boundary, to allow to define a direction in an unambiguous way

--
Good luck
Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL^® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Discussion Forum

A question on the contact problem

Suggested Content