Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Fluid Inlet

Posted 20 juin 2017, 12:19 UTC−4 Microfluidics Version 5.2a 2 Replies

Saurabh Sharma
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I want to show the inlet of fluid into multiple pipes placed in parallel to each other. I do not know how to select the inflow of fluid into the pipes. Because the pipe is hollow and I am not able to select the inlet face of the pipe.
2 Replies Last Post 20 juin 2017, 23:13 UTC−4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 20 juin 2017, 12:28 UTC−4
Hello Saurhab,
If I understand correctly, you are looking for the "Cap Faces" capability. See this thread where it was discussed: www.comsol.com/community/forums/general/thread/134711
Best,
Jeff
Hello Saurhab, If I understand correctly, you are looking for the "Cap Faces" capability. See this thread where it was discussed: https://www.comsol.com/community/forums/general/thread/134711 Best, Jeff
Saurabh Sharma
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 20 juin 2017, 23:13 UTC−4
Thanks a lot. I shall try that and will see if that helps.

Saurabh
Thanks a lot. I shall try that and will see if that helps. Saurabh

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content