Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Getting Zero Diagonal Error

Posted 3 nov. 2009, 09:47 UTC−5 1 Reply

santhosh onkar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I am trying to obtain lumped parameters(Capacitance matrix) for two cylindrical vias in a chip.

its a very elementary model.

i am getting zero diagonal error when i try to solve the problem (attached is the model).

any help/guidance in this regard would be very helpful,

thanks in advance,

-santhosh
1 Reply Last Post 3 nov. 2009, 14:38 UTC−5
Tom Myers
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 decades ago 3 nov. 2009, 14:38 UTC−5
Hi,

No model attached?

Regards,
Tom
Hi, No model attached? Regards, Tom

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content