Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How COMSOL calculates coils cross section?

Posted 20 avr. 2017, 13:06 UTC−4 Low-Frequency Electromagnetics Version 5.2a 1 Reply

Bulk Superconductivity
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am wondering how COMSOL calculates the cross section area of coil geometries. If I set for example a cylinder in COMSOL as a homogenized multi-turn coil, I am given the option to set the coil geometry. In there I can select the edge to set the direction of the rotation of the current. I have noted that the area that COMSOL calculates as the cross sectional area of the coil doesn't correspond to the actual area cross sectional of half the cylinder. I am wondering then how COMSOL calculates this value?

I know there is an option in coil geometry where I can override the default calculated cross-sectional area or use a multiplication factor to use in the right value in the geometry (which seems to be about 4 for cylinders). I have not been able to figure out how comsol calculates this area, I guess it changes according to the geometry? could it be that comsol can't recognize a cylinder as a proper geometry for a coil?
1 Reply Last Post 16 juil. 2017, 09:15 UTC−4
COMSOL Moderator

Hello Bulk Superconductivity

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Suraj R
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 16 juil. 2017, 09:15 UTC−4
I do have the same doubt. But how to include the domains instead of including edges because in my problem the coil is wounded around the whole cylinder not along the edges. And btw how did you calculate the multiplication factor. Can you give me an about that?
I do have the same doubt. But how to include the domains instead of including edges because in my problem the coil is wounded around the whole cylinder not along the edges. And btw how did you calculate the multiplication factor. Can you give me an about that?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content