Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coil simulation
Posted 7 févr. 2011, 08:17 UTC−5 Low-Frequency Electromagnetics Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
This is Pranith. I am simulating two coils. I want to give 5V voltage to one coil at 1 Mhz frequency and i have to see induced current and magnetic flux density normal but My problem is when i amusing terminal function to give voltage it is saying not applicable for ground function as well. can any one suggest me how to proceed further. Thanks in advanced. I am attaching my model.
Regards,
Pranith Tummala
This is Pranith. I am simulating two coils. I want to give 5V voltage to one coil at 1 Mhz frequency and i have to see induced current and magnetic flux density normal but My problem is when i amusing terminal function to give voltage it is saying not applicable for ground function as well. can any one suggest me how to proceed further. Thanks in advanced. I am attaching my model.
Regards,
Pranith Tummala
Attachments:
1 Reply Last Post 11 févr. 2011, 10:55 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I have the same problem...