Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D Meshing: Mapped vs Triangular

Posted 1 févr. 2017, 17:37 UTC−5 Mesh Version 5.2 0 Replies

Eric Aerosol Control Technology
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am solving a corona discharge problem with a 2D axisymmetric domain shown in the attachment. No convergence was achieved when using the Triangular mesh, but convergence was achieved when using a Mapped mesh.

As a COMSOL/FEM amateur, should I be confident about the converged solution using the Mapped mesh or should I be worried about the non-converged approach using the Triangular mesh?

Thanks.

Attachments:

0 Replies Last Post 1 févr. 2017, 17:37 UTC−5
COMSOL Moderator

Hello Eric

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content