Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
To find leakage inductance of a toroidal transformer
Posted 24 janv. 2011, 17:36 UTC−5 Low-Frequency Electromagnetics Version 3.5a, Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to find the leakage inductance of toroidal transformer using a 3D model. I made a 3D model using the equivalent Copper conductors as a single winding (not each windings separately).Then applied external current density to them. Then I found the leakage inductance from the magnetic energy density. This value is almost good when I compared with the axial symmetric model. But then I included the sector winding (or some portion of winding is kept as air), so in reality the magnetic energy density and leakage inductance should increase a lot. But I am not getting that increase in the magnetic energy density. But when I did the same using 2D top view of toroidal transformer, I am noticing this increase. Could you please help me out in this.
Thanks a lot.
Regards
Noel
Hello Noel Augustine
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam