Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Curvature radius of thick plate

Posted 9 janv. 2017, 03:05 UTC−5 Geometry, Structural Mechanics Version 5.2a 0 Replies

Kosuke Sakamoto
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone. I would like to simulate tensile stress on some thick plates with different hardness under the same curvature radius. I'm using COMSOL 5.2a.
(Actually materials are the same, but patterning is different)

I could simulate under the same force so far, but could not under the same curvature radius.
I would like to bend plates one direction, I mean it is like surface of the cylinder, not like surface of the ball.

I hope somebody help me.
Thanks in advance for any help.

0 Replies Last Post 9 janv. 2017, 03:05 UTC−5
COMSOL Moderator

Hello Kosuke Sakamoto

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content