Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to check the normal of a shell?

Posted 6 déc. 2016, 20:44 UTC−5 2 Replies

Linus
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Greetings,

I realised the normal of a shell structure will only be revealed after computation in one of the default plots.

However, is checking the normal possible during modelling?

Thank you.
2 Replies Last Post 8 déc. 2016, 02:19 UTC−5
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 7 déc. 2016, 08:11 UTC−5
Hi,

The default plot is the best way. You do not have to do a full solution to get it. "Get Initial Value" from the Study node is sufficient (and fast).

Regards,
Henrik
Hi, The default plot is the best way. You do not have to do a full solution to get it. "Get Initial Value" from the Study node is sufficient (and fast). Regards, Henrik
Linus
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 8 déc. 2016, 02:19 UTC−5
Thank you, Henrik. Your suggestion works!
Thank you, Henrik. Your suggestion works!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content