Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Forced timestep size for transient simulation
Posted 5 déc. 2016, 03:29 UTC−5 Fluid & Heat, Heat Transfer & Phase Change, Studies & Solvers Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
I would like to know, whether it is possible at all to force COMSOL to use large timesteps? I do not care about accuracy right now, I want to test a setup and have direct control over the temporal resolution. I have tried everything - but I cannot make any sense of how the "relative tolerance" of the time-dependent solver controls things.
Sincerely,
Joe
Hello Joe Alexandersen
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.