Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Strain as an output of Hygroscopic Swelling modelling

Posted 7 nov. 2016, 23:27 UTC−5 Version 5.2a 2 Replies

Reza V
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a question and I appreciate your help in this regard. In simulation of Hygroscopic Swelling (deformation of material due to moisture absorption), we enter formulation for moisture related strain (EM) in the software. What is the output of software for strain, the total strain (E) or elastic strain (EE)? (EE=E-EM) or, should we compute elastic strain (EE) after making extra calculation on the outputs of software?

2 Replies Last Post 9 nov. 2016, 20:31 UTC−5
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 9 nov. 2016, 12:50 UTC−5
Hi,

You can choose which to present. Both total (solid.eXX or solid.el11) and elastic strains (solid.eel11) are available in the plot menus.

Regards,
Henrik
Hi, You can choose which to present. Both total (solid.eXX or solid.el11) and elastic strains (solid.eel11) are available in the plot menus. Regards, Henrik
Reza V
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 9 nov. 2016, 20:31 UTC−5
Thank you, Henrik. It was really helpful.
Thank you, Henrik. It was really helpful.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content