Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

modeling cylindre concentric

Posted 15 oct. 2016, 17:29 UTC−4 Version 4.3 1 Reply

Djemaa Guerraiche
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

i need to modeling tow cylindre concentical
1 Reply Last Post 17 oct. 2016, 11:29 UTC−4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 17 oct. 2016, 11:29 UTC−4
I am not quite sure what your question is, but geometry capabilities are documented in Chapter 7 of the Reference Manual, version 5.2a. Drawing concentric cylinders is as simple as drawing two cylinders and making sure to specify coordinates for them that assures they are concentric. Alternatively, you can use the "Layers" section of the cylinder settings window.
Best regards,
Jeff
I am not quite sure what your question is, but geometry capabilities are documented in Chapter 7 of the Reference Manual, version 5.2a. Drawing concentric cylinders is as simple as drawing two cylinders and making sure to specify coordinates for them that assures they are concentric. Alternatively, you can use the "Layers" section of the cylinder settings window. Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content