Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to define line of symmetry, ie above and below are mirror images
Posted 18 déc. 2010, 05:20 UTC−5 Heat Transfer & Phase Change, Structural Mechanics Version 4.1 2 Replies
Please login with a confirmed email address before reporting spam
I have a cylinder with some stuff placed in it on the x-axis and want to calculate the stress in the caused by the difference in thermal expansion.
I want to use the symmetry of the x-axis but I dont get how to do this. I've found this page www.comsol.com/support/knowledgebase/1038/ describing roughly how to do it but I dont understand the last part where I choose '"Symmetry", "Insulation" or similar'.
Does someone know how to specify the line along the x-asis as a line of symmetry?
In the thermal stress package I have the options of:
Pairs>Symmetry or
Pairs>Continuity
If I choose Symmetry I cant select annything... what to doo?
Hello Micke Malmström
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have the same problem. Do you have an aswer or did y ou find how to do it? Please let me know it is very important.
Best regards,
nicolas
Please login with a confirmed email address before reporting spam