Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to drow an open box with a specific thickness?

Posted 9 déc. 2010, 01:55 UTC−5 Geometry, Results & Visualization Version 3.5a 2 Replies

arguani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am not sure if my question is easy or not. How to draw a box as geometry (open at the top)? with a thickness of 1 cm. I have tried to do it by drawing the walls in each side, but I think this will increase the number of the edges (I have attached a pic).

Something else, how can I export the data (temperature) in a specific layer of a geometry (middle). I have attached a pic.

Version 3.5a.

Thank you

Attachments:

2 Replies Last Post 10 déc. 2010, 23:17 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 déc. 2010, 02:12 UTC−5
Hi

there is harly any loss having internal boundaries in COMSOL so your way is OK, you can alo draw two boxes , one inside the other and then "substract" the inner from the outer and you will have a hollow "box", if you place both with a common surface you will have an open box

--
Good luck
Ivar
Hi there is harly any loss having internal boundaries in COMSOL so your way is OK, you can alo draw two boxes , one inside the other and then "substract" the inner from the outer and you will have a hollow "box", if you place both with a common surface you will have an open box -- Good luck Ivar
arguani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 déc. 2010, 23:17 UTC−5
Hi Ivar,

Thanks a lot. Your replay helped me a lot.
Hi Ivar, Thanks a lot. Your replay helped me a lot.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content