Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

ERROR when doing the parametric sweep!!!

Posted 22 nov. 2010, 07:21 UTC−5 1 Reply

Yong LI
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I use the COMSOL 4.1 to do some parametric sweep, but the error appeared.

Attachments:

1 Reply Last Post 22 nov. 2010, 10:21 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22 nov. 2010, 10:21 UTC−5
Hi

reading in old models are not always possible, I always restart from scratch, the best copying from the fields

Try a "file clear solution, clear mesh, reset model", and then rerun it

--
Good luck
Ivar
Hi reading in old models are not always possible, I always restart from scratch, the best copying from the fields Try a "file clear solution, clear mesh, reset model", and then rerun it -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content