Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

In-floor heating system

Posted 13 avr. 2016, 05:11 UTC−4 Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD) 1 Reply

Christina Karagianni
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,I'm interested in using the program in my master thesis. I want to simulate an in-floor heating system in an urban environment.Can this be done?
Thank you.
Christina
1 Reply Last Post 14 avr. 2016, 11:34 UTC−4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 14 avr. 2016, 11:34 UTC−4
Hello Christina,
Yes, it is possible to model radiant floor heating. You would use the Pipe Flow Module for that type of modeling: www.comsol.com/pipe-flow-module .
See also this example: www.comsol.com/model/heat-recovery-system-for-a-geothermal-heat-pump-18529 .
Best regards,
Jeff
Hello Christina, Yes, it is possible to model radiant floor heating. You would use the Pipe Flow Module for that type of modeling: https://www.comsol.com/pipe-flow-module . See also this example: https://www.comsol.com/model/heat-recovery-system-for-a-geothermal-heat-pump-18529 . Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content