Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Pressure contour near outlet boundary is variable
Posted 1 mars 2016, 14:07 UTC−5 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
Hi, everyone,
I employed the COMSOL Laminar Flow model to simulate parallel plate flow. In the Laminar Flow model, I exerted inlet pressure boundary (a constant value) and outlet pressure boundary (another constant value). It runes well in this simulation and didn't get any warning or error. But I came to find that the pressure contour near outlet boundary is variable, not constant. It's attached below. Who knows the cause and cure. Thanks a lot.
I employed the COMSOL Laminar Flow model to simulate parallel plate flow. In the Laminar Flow model, I exerted inlet pressure boundary (a constant value) and outlet pressure boundary (another constant value). It runes well in this simulation and didn't get any warning or error. But I came to find that the pressure contour near outlet boundary is variable, not constant. It's attached below. Who knows the cause and cure. Thanks a lot.
1 Reply Last Post 1 mars 2016, 14:11 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
The attachment is the pressure contour near outlet boundary.
Attachments: