Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

solidification

Posted 20 févr. 2016, 07:50 UTC−5 Heat Transfer & Phase Change, Mesh, Modeling Tools & Definitions 2 Replies

Idir Lasloudji
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,
I would like to simulate solidification phenomena coupled to fluid mechanics but in COMSOL only apparent heat capacity is available in ready physics. Is it possible to use phase field, level set method and how to couple it to heat transfer? Is it possible to implement enthalpy-porosity in COMSOL using PDE or weak formulation? Could you give me some guidelines and documentation?
Thank you.
2 Replies Last Post 21 avr. 2017, 11:09 UTC−4
COMSOL Moderator

Hello Idir Lasloudji

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Tushar Telmasre
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 5 févr. 2017, 13:25 UTC−5
I am also trying to solve it using heat source method. What I did try is use simple heat transfer module and then manipulate the source term. You can also try using PDE interfaces in Mathematics section while selecting Physics.
I am also trying to solve it using heat source method. What I did try is use simple heat transfer module and then manipulate the source term. You can also try using PDE interfaces in Mathematics section while selecting Physics.
Idir Lasloudji
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 21 avr. 2017, 11:09 UTC−4
Hello Tushar,

Thank you for your reply.

Hello Tushar, Thank you for your reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content