Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Can i make the coil current in the single-turn coil a negative number??

Posted 25 janv. 2016, 01:57 UTC−5 Low-Frequency Electromagnetics Version 5.1 2 Replies

Eric Yuan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi!

I simulate a 2-D modle.There are two single-turn coils that is series connection. The parameters of the coils are all same except their coil currents are contrary.So i should make a one coil's current is a positive number and other coil's current is a negative number?Or what should i do that can express their coil current is contrary in 2-D modle??

thank you

Attachments:

2 Replies Last Post 25 janv. 2016, 21:41 UTC−5
Jens Krause
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 25 janv. 2016, 08:16 UTC−5
The single turn feature can have sub node "Reversed Current Direction ". Rght click on the model tree.

Regards

Jens
The single turn feature can have sub node "Reversed Current Direction ". Rght click on the model tree. Regards Jens
Eric Yuan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 25 janv. 2016, 21:41 UTC−5
thank you!!
I get it!
thank you!! I get it!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content