Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

[solved] damped oscillations in a piezoelectric cantilever

Posted 6 oct. 2010, 11:55 UTC−4 4 Replies

Andrea Mazzalai
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam




Attachments:

4 Replies Last Post 14 oct. 2010, 12:32 UTC−4
Alex Schenk
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 8 oct. 2010, 06:44 UTC−4
I can't look at your model because I dont have COMSOL on this computer, but wouldnt the damping effect be due to the fact that your cantilever is made of two different materials, each of which will respond differently to the oscillation?
I can't look at your model because I dont have COMSOL on this computer, but wouldnt the damping effect be due to the fact that your cantilever is made of two different materials, each of which will respond differently to the oscillation?
Andrea Mazzalai
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 12 oct. 2010, 11:15 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13 oct. 2010, 01:44 UTC−4
Hi

depending on how you connect up electrically your PZT you could have damping, there might be some "numerical damping" I believe for stability reasons, check the doc

--
Good luck
Ivar
Hi depending on how you connect up electrically your PZT you could have damping, there might be some "numerical damping" I believe for stability reasons, check the doc -- Good luck Ivar
Andrea Mazzalai
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14 oct. 2010, 12:32 UTC−4
Good evening,

I found the problem. It was due to a too large time stepping in the transient analysis settings.

With 1/100 of the period as time step everything works fine.
Good evening, I found the problem. It was due to a too large time stepping in the transient analysis settings. With 1/100 of the period as time step everything works fine.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content